Gasboy 03908X User Manual download pdf (Page 21)

MDE-4351A Gasboy ATC Kits 039086 and 039087 Installation Manual • February 2006 Page 21

Installation

Figure 20: 460A4 Circuit Board in Place with Connections Made

In the kit, locate the W172 3-wire harness for IS Barrier.

20 Place the connector on the harness on P5 of the LP-70 Polycase box (Figure 19).

21 Using three of the crimp splices, connect the wires of the harness to the wires extending from

the top of the IS barrier. Match color codes.

22 Connect the ground wire (wire with eyelet connector) to the nearest true ground.

23 Disconnect cable going to P6 connector of the Pump CPU board.

24 Connect the cable that was disconnected in previous step to P9 connector in the LP-70

Polycase box.

25 If the user wants to be able to display electronic totals, a second cable (C06003) must be

installed and connected to the P6 connector on the Pump CPU board.

26 In the LP-70 Polycase box, locate the DIP switches shown in Figure 19 and set the switches

for the proper unit as shown in the following table:

DIP Switch Settings

Switch

Number Switch Function Settings

1 Product 1 ON for Diesel, OFF for Gasoline

2 Product 2 ON for Diesel, OFF for Gasoline

3 Not used N/A

4 Not used N/A

5 Pulser Multiplier ON for 9850, OFF for 9852/9853

6 Number of Probes ON for two (2) probes, OFF for one (1) probe

W283 Display Adapter

Connector on J4

460A4 Circuit

Board Assembly

1 2 ... 16 17 18 19 20 21 22 23 24 25 26

No comments

Gasboy 03908X User Manual Page 21