Gasboy 03908X User Manual download pdf (Page 16)

Installation

Page 16 MDE-4351A Gasboy ATC Kits 039086 and 039087 Installation Manual • February 2006

39 Connect the other end of the probe to Probe Connector Assembly in the connector labeled “1”.

(See Figure 4 for Probe Connector Assembly location.)

40 Go to “Completing Installation” on page 24 in this manual.

Installing the 039087 ATC Kit in Twin Unit

1 In the kit, locate the LP-70 Polycase box with SK449C PCB mounted inside. Remove the four

mounting screws securing the cover and remove the cover from the box. Save screws and

cover for reinstalling later.

2 Peel the protective cover from the mounting sponge (on the back of the polycase box) and

mount the box as shown in Figure 13. Mount approximately 1/2-inch up from shelf.

Figure 13: Mounting the LP-70 Polycase Box

In the kit, locate the 218AY00 single IS barrier and 212AY05 dual probe connector assembly.

Remove the nut and washer from the mounting stud on the IS barrier and slide them off the

wires. Save for reuse.

4 Feed the wires extending from the IS barrier mounting stud through the hole in the shelf as

shown in Figure 14 and place the mounting stud through the hole.

Approximately

1/2-inch

Clearance

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 25 26

No comments

Gasboy 03908X User Manual Page 16