Gasboy Site Controller II CPU User Manual download pdf (Page 17)

MDE-4504 Site Controller II CPU/Memory Board/Program Upgrade Instructions · August 2005 Page 13

Installing New Software Upgrading

Installing New Software

Select the appropriate procedure (from the list below) to install new software:

• If your system has dual floppy drives, and you are upgrading from V1.0x to V2.0x or

above, follow

“Procedure A” on page 13.

• If your system has a hard drive and a floppy drive, and you are upgrading from V1.0x to

V2.0x or above, follow

“Procedure B” on page 14.

• For all system types, if you are upgrading from a 2.0x version to a higher 2.0x or above,

“Procedure C” on page 15.

Procedure A

1 With the new Release disk in the A: drive, hold the CPU reset button for 10 seconds while

powering-up the SC II.

2 Sign on after the files are reconstructed.

3 Insert the new Applications disk in the B: drive.

4 Type FIX TR;I and press ENTER.

5 Type RESTORE EV and press ENTER.

6 Type RESTORE TRANS FR TRANBACK.DTA and press ENTER.

7 Type LO TR xxxx and press ENTER.(xxxx = trans # is noted in step 7 of “Taking Backup”

on page 3.)

8 Type AD SIG and load the users, permission levels, and sign on codes. Refer to step 5 of

“Taking Backup” on page 3.

9 Type RUN;I and press ENTER.

10 Type SYSBACK and press ENTER.

11 Use the CP command to copy any user-created files from the V1.0 Release disk to the new

Release or Applications disk.

12 Once the site is up and running, secure the cover to the Site Controller.

13 Update the spare Release disk made while executing step 5 of “Taking Backup” on page 3, or

use SWAPCOPY+ to copy the entire Release disk again.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 25 26

No comments

Gasboy Site Controller II CPU User Manual Page 17